FWE HLC-7 Mobile Heated Holding Cabinet

The HLC-7 accommodates shallow and deep 12" x 20" and GN 1/1 pans. FWE's unique pan slide racks are one piece die-stamped stainless steel, providing greater hygiene and strength. The front edges are relieved for easy loading and the pair of racks are removable for easy cleaning.

Simply load the HLC-7 with your pans of cooked, hot food and this warmer will keep your food hot and ready until serving time.

Radiant heat rises naturally and circulates from bottom to top without blowers. The heat system is built into the cabinet to reduce maintenance and cleaning costs. The electronic controls are upfront and eye level, featuring a full range thermometer and thermostat with a scale of 90 degrees F to 190 degrees F.

Features

• CONSTRUCTION - Heliarc welded single unit construction of stainless steel; 20 gauge polished exterior, 22 gauge stainless steel interior with easy-to-clean coved corners.
• INSULATION - "Ultra-Guard" UG-26 high-density fibreglass insulation throughout; top, back, bottom, sides and door(s).
• DOORS AND LATCHES - Flush mounted, double pan, stainless steel doors shall have 1 thick fibreglass insulation. Single door models are field reversible. High-temperature door gasket mounted on cabinet. Each door shall be equipped with a horizontal magnetic workflow handle. Each door shall have two (2) heavy-duty edge mount die cast hinges.
• CASTERS - Maintenance free polyurethane tire casters in a configuration of four (4) swivel with brake. Casters shall have a reinforced yoke mounted to 10 gauge caster plate. The caster mounting plate shall be secured to a 10 gauge stainless steel reinforcing stress plate via welded in place stainless steel studs.
• PAN SLIDES - Stainless steel racks shall be one piece die stamped channel-type pan slides at 2.625 (66.7 mm) spacings to accommodate either deep or shallow 12 x 20 or GN 1/1 pans (at varying capacities - see chart). Racks are removable without tools for cleaning. Racks shall lift off heavy-duty stainless steel supports.
• HEATING SYSTEM/CONTROLS - Radiant heat system shall include an Incoloy nickel-chromium alloy heating element. Electronic controls shall include an easy to read digital display of cabinet temperature (with recall capacity of temperature set point and actual cabinet temperature), equipped with a programmable low-temperature alarm, master ON/OFF switch with power indicator light. Adjustable temperature range from 90°F to 190°F (32°C to 88°C).
• ELECTRICAL CHARACTERISTICS - 3 wire grounded tri-directional power cord and plug, rear mounted for safety.
• INSTALLATION - Unit should not be installed in an area where adverse environmental conditions are present.